Back to Blog

Conformal Coating Facility Setup: General Requirements

Posted by Sean Horn

Monday, August 6, 2012 12:23

@ 12:23 PM

We get a lot of requests from customers looking to keep their conformal coating an in-house process.  A lot goes into the conformal coating process, so it may be easy to overlook allThe coating room area should be clean and dust free since printed circuit boards are especially susceptible to particles sticking to the drying coating.  The temperature range should be reasonably controlled within the sensible limits since the visocity of the coating is dependent upon the temperature.  However, a more critical point than temperature is the humidty which needs to be controlled to be above 35% for ESD reasons and <55% due to moisture issues which can affect the coating integrity and the application method.

Extraction will be required because of the solvents being used in the spraying process.  The extent of the extraction will be determined by your local, state, and federal governments, so carefully check the laws and regulations that apply to you.

In our next post, we will discuss the equipment that is needed to operate a proper conformal coating facility.

Diamond-MT has over 25 years experience with conformal coatings and can offer consulting and training on setting up a turnkey operation for companies planning on running their own in house conformal coating operations.

Comments

londondrugscanada.bigcartel.comlondon-drugs 4/17/2020. 10:17:10 AM

cialis uk https://londondrugscanada.bigcartel.com/london-drugs This is nicely expressed. !

Homepage 4/17/2020. 10:17:10 AM

... [Trackback] [...] Informations on that Topic: blog.paryleneconformalcoating.com/whats-the-difference-between-potting-and-conformal-coating/ [...]